5
YOUR • QCA • SPA • EQUIPMENT
Q2000 Control
Jets Control
Initial Start Up
When first powered up, your spa will automatically
heat and maintain 100° F or 38° C until you
change the set temperature.
Press the Jets pad once to turn on the pump and
ozone generator (if installed). The pump and the
ozone generator (if installed) will turn off after 15
minutes or will run until set temperature is
reached.
Temperature Adjustment (80° F - 104° F)
Freeze Protection
Press the set pad to display the temperature
previously set. Pressing the pad a second time will
cause the set temperature to increase or decrease in
1° F increments depending upon what direction
was last chosen. Each successive press will
change the set temperature in the same direction. If
the opposite direction is desired, release the pad
and let the display revert to the actual water
temperature again. Press the pad to display the set
temperature, and again to make the temperature
change in the desired direction.
If the high-limit sensor detects 40° F (4°C) then
the pump is automatically activated to provide
freeze protection. This is a normal spa function:
no corrective action is necessary. The pump stays
on until the sensor detects 45°. Freeze protection
is enabled regardless of the spa’s status.
WARNING
This equipment generates and uses radio frequency energy and if not installed and used properly, that is in strict
accordance with the manufacturer’s instruction may cause interference to radio and television reception. It has
been type tested and found to comply with the limits for a class B computing device in accordance with the
specification in subpart J of part 15 of the FCC guarantee that interference will not occur in a particular installation.
If this equipment does cause interference, which can be determined by turning the equipment on and off, the user is
encouraged to try to correct the interference by one or more of the following measurers: Reorient the receiving
antenna. Relocate the receiver with respect to the spa. Move the receiver away from the spa. Plug the receiver into
a different outlet so that the receiver and spa are on different circuits. If necessary, the user may find the following
booklet prepared by the Federal Communications Commission helpful: "How to identify and resolve radio-TV
interference problems." This booklet is available from the U.S.Government Printing Office, Washington, DC
20402, Stock No. 004-000 00345-4.
(10 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals